- A0 - A5, C2 and C5 (Are usually routed to PIC pins RA0 - RA5, RC2 and RC5).
- Ports A0 - A3 have 1k resistors in series with them, so they can be used as analog or digital inputs. There are 4 solder straps situated next to the resistor network, that will short out the resistors when made. This can be usefull in case Ports A0 - A3 are used as outputs.
When connected to a MicroX Main Board (SBC), it can provide the SBC with power by supplying power to the terminal block pins 9 and 10. Note, when doing this no power should be applied to the SBC!
Frontend connector pin B6 (Usually routed to PIC port pin RB6) is connected to a red LED.
It is fully assembled, and supplied with the terminal block connector and plug as shown in the photo above.
The board schematics and PCB layout can be downloaded